Juan Carlos De Campo Salomon

• Manufacturing of Power train components: Dual mass flywheels, Discs, Clutches, Self adjusting clutches and double Clutches for power shift transitions • Production transfer. • 250 million USD Annual Turn over. • P&L analysis focused on the production cost impact and cost reduction. • Business case justification. • Productivity & P+L improvements.

• Investment planning and production Headcount • Design of production lines, including the purchase of the machines, installation and start up of the production. • Process and costs analysis, controlling the machine’s capacities and utilization. • Cost calculation for new products • Lean Manufacturing responsible. • Responsible for the manufacturing engineering of machining, assembly, press shop and HT areas. • Industrialization projects • Production transfer (Germany – USA – Mexico).

Introduction of new projects in the context of the APQP and PPAP. according to our customers depends, e.g. PSO for Daimler Chrysler or VDA 6,1 for Volkswagen. • Design and Construction of machines • Lay outs design, including purchase of the machines and release in to production. • Regular activities as Manufacturing engineer such as PFMEA, route sheets, work instructions, layouts, control plans, etc.

• Introduction of new projects in the context of the APQP and PPAP. • In eight months, 10 introductions of new products for OE customers (APQP and PPAP), and 10 for After mark customers • Further training and introduction of the German LuK software for project administrator (PV-2) in the entire LuK factory in Puebla

• Enabled for the use of LuK-Software “Projektverfolgung –V. 2” (PV-2) • Training in production process such as: ​- Heat treatment, Assembly lines, and Investment calculations.

• Construction of new tools and device for new products • Upgrade of the Lay out the assembly lines in the company. • Transport and packing calculations • Investment calculations • Automation on of the production lines • Regular activities as Manufacturing engineer such as PFMEA, route sheets, work instructions, layouts, control plans, etc.

• Design of the smoke extraction system • Design of the process automation. • Metallographic analyse • Regular activities as Manufacturing engineer such as PFMEA, route sheets, work instructions, layouts, control plans, etc.

• Investment Calculations • Construction and installation of Presses Acoustic cabin • Layout improvement of the entire Press department. • Works with the set-up sheets • Process realises of the new products. • Programming and calibrating of the new spring measuring machine.

​Thesis (Diploma): Optimize the production’s process.